For a low carbon steel tube with small wall factor D/t and bending radius R,the over-thinning induced localized necking is one dominant failure in tube numerical control(NC) bending process,which strongly restricts the bendability limit of the tube.In addition,the deterioration of bendability of a tube is increased by the existence of the weak weld region.Therefore,an important issue is how to determinate and predict the welded tube bendability limit.In the present study,a finite element(FE) model with weld and subdivided heat affected zones under ABAQUS platform is employed to explore the deformation behaviors of welded tube NC bending.A localized necking criterion based on the critical thickness thinning is used to predict the critical principal strains,critical bending radius and burst location during the forming process.It is found that the failures always occur at the rigid supporting point of mandrel flexible balls near the tangent point at the outside of the bend,where the wall thickness of the tube is the lowest.The bending limit curves(BLCs) of the QSTE340 welded tube are obtained by shifting the standard shaped forming limit curve to the critical principal strains along the major strain axis.Comparison between the numerical and experimental results has shown that the BLC and critical bending radius predictions agree well with the experimental results.In addition,the effect of weld positions on BLC is discussed,the weld region shows an almost negligible effect on the forming limit at a non-critical location that is far away from the outside of the bend.However,when the weld is at the large tensile deformation region on the outside of the bend,a decrease of the forming limit strains is seen.
YANG HeREN NingZHAN MeiZHANG ZhiYongQIN YaTaoJIANG HaoMinDIAO KeShanCHEN XinPing
The mechanical characteristics of the weld joint were investigated by tensile test, microstructure test, and microhardness test. The welded tube NC bending tests were carried out to evaluate the weld on the formability of the QSTE340 welded tube. The results show that the wall thinning degree, cross-sectional deformation and springback angle increase significantly as the weld line is located on the outside of the bend compared with that located on the middle and inside, and the welded tubes produce nearly identical performance as the weld line is located on the middle and inside. The wall thickening degree decreases much as the weld line is located on the inside of the bend. So the welded tube can acquire good bending formability as the weld line is located in the region away from the outside of the bend.
Thin-walled aluminum alloy tube numerical control （NC） bending with small bending radius is a complex process with multi-factor coupling effects and multi-die constraints. A significance-based optimization method of the parameters was proposed based on the finite element （FE） simulation, and the significance analysis of the processing parameters on the forming quality in terms of the maximum wall thinning ratio and the maximum cross section distortion degree was implemented using the fractional factorial design. The optimum value of the significant parameter, the clearance between the tube and the wiper die, was obtained, and the values of the other parameters, including the friction coefficients and the clearances between the tube and the dies, the mandrel extension length and the boost velocity were estimated. The results are applied to aluminum alloy tube NC bending d50 mm×1 mm×75 mm and d70 mm×1.5 mm×105 mm （initial tube outside diameter D0 × initial tube wall thickness t0 × bending radius R）, and qualified tubes are produced.
