Lamellar crystals of diblock, triblock and four-arm poly（ethylene glycol）-b-poly（ε-caprolactone） （PEG-b-PCL） crystalline-crystalline copolymers were successfully obtained from their solution. Morphology and structure of lamellar crystals of crystalline-crystalline copotymers were investigated using tapping-mode atomic force microscopy （AFM） and selected area electron diffraction （SAED）. All of these samples showed the truncated-lozenge multilayer basal shapes with central screw dislocation or central stack, which were all obtained simultaneously from the oil bath. The diffraction pattern of PEG block lamellar crystal is attributed to the （120） diffracting planes and the pattern of PCL block lamellar crystal is attributed to the （1 I0） diffracting planes and （200） diffracting planes according to the SAED results. Four （110） crystal growth planes and two （200） crystal growth planes are discovered for the PCL blocks, but the （120） crystal growth planes of PEG blocks are hided in the figure of AFM. The crystalline structure of the four-arm copolymers （FA） is more disorder and confused than that of the diblock （DI） copolymer and the striated fold surface structures of lamellar crystals of four-arm copolymers （FA） are smoother than these of linear analogues, owing to the confused crystallization of blocks caused by the mutual restriction of blocks and the hindrance of the dendritic cores. In addition, the aspect ratio of FA is greater than that of the others. It is hypothesized that there are two reasons for the change of aspect ratios. First, the （200） diffracting planes of PCL crystals grew slowly compared to their （110） diffracting planes because of difference in the energy barrier. Secondly, edge dislocations on the （200） diffracting planes are also responsible for the variation of the aspect ratio. Consequently, the crystalline defects are augmented by the competing blocks crystallized simultaneously and the hindrance of the dendritic cores.
Ultra-high molecular weight polyethylene（UHMWPE）/chitin nanocrystal（CNC） fibers were prepared. Compared with the pure UHMWPE fibers, the ultimate tensile strength and Young＇s modulus of UHMWPE/CNC fibers are improved by 15.7% and 49.6%, respectively, with the addition of chitin nanocrystals（CNCs） of 1 wt%. The melting temperature（Tm） of UHMWPE/CNC fibers was higher than that of pure UHMWPE fibers. Pure UHMWPE fibers and UHMWPE/CNC fibers were characterized with respect to crystallinity, orientation and kebab structure by wide-angle X-ray diffraction（WAXD）, small-angle X-ray scattering（SAXS） and scanning electron microscopy（SEM）. It is found that the CNCs act as the shish structure in UHMWPE/CNC fibers and the kebab crystals are grown around the CNCs. There was almost no difference between pure UHMWPE fibers and UHMWPE/CNC fibers in orientation. But the degree of crystallinity of various stages of UHMWPE/CNC fibers was respectively higher than the corresponding stage of pure UHMWPE fibers. Moreover, the addition of 1 wt% CNCs improved the thickness of kebab crystals and accelerated the transformation of kebab to shish.
