The linear elasticity was studied in a martens- tic alloy NisoMn25Ga9Cu16. A 0.4 % linear elastic strain is btained in the polycrystalline sample under compressive stress of 745 MPa. The elastic modulus is 186 GPa. The obtained linear elastic strain and elastic modulus are much higher than that of ternary Ni-Mn-Ga martensitic alloys.~.bstract The linear elasticity was studied in a martens- tic alloy NisoMn25Ga9Cu16. A 0.4 % linear elastic strain is ~btained in the polycrystalline sample under compressive stress of 745 MPa. The elastic modulus is 186 GPa. The obtained linear elastic strain and elastic modulus are much higher than that of ternary Ni-Mn-Ga martensitic alloys.
The microstructure and magnetostrictive properties were investigated in the Tb doped Fe83Ga17-xTbx（x = 0.05, 0.10, 0.20, 0.30, 0.40, 0.50） bulk rods prepared by melt rapidly quenching. The partial solid solubility of Tb in the Fe-Ga matrix was preliminary detected by the lattice parameters and SEM observation. The matrix keeps A2 structure and the second phase appears surround the grain boundary as x C 0.1. h100 i preferred orientation is also observed for x = 0.1 sample along the axis of the quenched rod. The saturation magnetostriction first increases and maximum value reaches at x = 0.1, and then decreases with Tb addition increasing. The initial increase of the magnetostriction should be associated with the partial solution of Tb in the matrix, the maximum value at x = 0.1 should be attributed to the h100 i preferred orientation, and the decrease of the magnetostriction is correlated with the appearance of the second phase along the grain boundary.
Ni30Cu20Mn37＋xGa13-x（x = 0–4.5） alloys were studied with the phase transformation and mechanical properties. With the increase of Mn content, the martensitic transformation temperatures increase and the Curie temperature decreases. Simultaneously, the room temperature microstructure evolves from single phase of austenite to dual phases containing martensite and precipitation. Both the ductility and the strength of the polycrystalline alloys are significantly improved by the precipitation. Coupled magnetostructural transition from weak magnetic martensite to ferromagnetic austenite is obtained in both single-phase and ductile dual-phase alloys.
