TiO2 supports doped with different amounts of Si were prepared by a sol-gel method, and 1 wt% vanadia （V2O5） loaded on Si-doped TiO2 was obtained by an impregnation method. The mole ratio of Si/Ti was 0.2, NOx conversion exceeds 94% at 300℃ and GHSV of 41,324 hr-1 , which is about 20% higher than pure V2O5/TiO2 . The catalysts were characterized by XRD, BET, TEM, FT-IR, NH3-TPD, XPS, H2-TPR, Raman and in situ DRIFTS. The results of FT-IR and XPS indicated that Si was doped into the TiO2 lattice successfully and a solid solution was obtained. V2O5 active component could be dispersed well on the support with the increasing of surface area of the catalyst, which was confirmed by Raman and XRD results. Above all, the numbers of acid sites （especially the Br nsted-acid） and oxidation properties were enhanced for Si-doped V2O5/TiO2 catalysts, which improved the deNOx catalytic activity.
A series of Ce-doped MnOx/TiO2 catalysts were prepared by impregnation method and used for catalytic oxidation of NO in the presence of excess O2. The sample with the Ce doping concentration of Ce/Mn=l/3 and calcined at 300 ℃ shows a superior activity for NO oxidation to NO2. On Ce（1）Mn（3）Ti catalyst, 58% NO conversion was obtained at 200 ℃ and 85% NO conversion at 250 ℃ with a GHSV of 41000 h-1, which was much higher than that over MnOx/TiO2 catalyst （48% at 250 ℃）. Characterization results implied that the higher activity of Ce（1）Mn（3）Ti could be attributed to the enrichment of well-dispersed MnO2 on the surface and the abundance of Mn3＋ and Zi3＋ species. The addition of Ce into MnO2/TiO2 could improve oxygen storage capacity and facilitate oxygen mobility of the catalyst as shown by PL and ESR, so that its activity for NO oxidation could be enhanced. The effect of H2O and SO2 on the catalyst activity was also investigated.
