The oxidation of elemental mercury （Hg~） by dielectric barrier discharge reactors was studied at room temperature, where concentric cylinder discharge reactor （CCDR） and surface discharge plasma reactor （SDPR） were employed. The parameters （e.g. Hg^0 oxidation efficiency, energy constant, energy yield, energy consumption, and O3 concentration） were discussed. From comparison of the two reactors, higher Hg^0 oxidation efficiency and energy constant in the SDPR system were obtained by using lower specific energy density. At the same applied voltage, energy yield in the SDPR system was larger than that in the CCDR system, and energy consumption in the SDPR system was much less. Additionally, more 03 was generated in the SDPR system. The experimental results showed that 98% of Hg^0 oxidation efficiency, 0.6 J·L^-1 of energy constant, 13.7 μg·J^-1 of energy yield, 15.1 eV·molecule^-1 of energy consumption, and 12.7 μg·J^-1 of O3 concentration were achieved in the SDPR system. The study reveals an alternative and economical technology for Hg^0 oxidation in the coal-fired flue gas.
An atmospheric-pressure argon plasma jet with screw ring-ring electrodes in surface dielectric barrier discharge is generated by a sinusoidal excitation voltage at 8 kHz. The discharge characteristics, such as rotational and vibrational temperature of nitrogen, electronic excitation temperature, oxygen atomic density, nitrogen molecular density, and average electron density, are estimated. It is found that the rotational temperature of nitrogen is in the range of 352 ～ 392 K by comparing the simulated spectrum with the measured spectrum at the C3Πu → B3Πg （△ν = 2） band transition, the electronic excitation temperature is found to be in the range of 3127 ～ 3230 K by using the Boltzmann plot method, the oxygen atomic and nitrogen molecular density are of the order of magnitude of 1016 cm-3 by the actinometry method, and the average electron density is of the order of magnitude of 1012 cm-3 by the energy balance equation. Besides, the effective power, conduction, and displacement current are measured during the discharge.
